A1h for lp8556

sijie

Hi everyone

I set the default value of A1h to 0xAD.now,I've defined a node to change the value of A1h to change the current.After starting up, the value of A1H was changed to 0xCD by the node, and the current was found to be unchanged

Best Regards,

over 4 years ago

0 Frank Qiu over 4 years ago

TI__Genius 15776 points

Hi Sijie, please describe your issue more detial, our expert will help you later.

0 Frank Qiu over 4 years ago in reply to Frank Qiu

TI__Genius 15776 points

If there is no further feedback I will close this thread.

0 Hardy Wu over 4 years ago

TI__Genius 12915 points

Hi Sijie,

You mean you are using E05 version that programming the pre-configured register? The EPROM can only be programmed by one time and cannot change the default setting in further use. You need to change the value every time powering up.

0 Frank Qiu over 4 years ago in reply to Hardy Wu

TI__Genius 15776 points

If there is no further feedback I will close this thread.

Power management

Power management forum

A1h for lp8556