This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BQ25792EVM: converter is working even though i removed the thermistor

Part Number: BQ25792EVM
Other Parts Discussed in Thread: BQ25792

Hi,

     I am using BQ25792 to charge 14.4V battery. but my converter was not working . You suggested to remove thermistor.  even though i removed i didnt observe a square wave form at SW1/SW2.

Please reply me

Best Regards,

Malesh Nakka

  • H Malesh,

    What is your input voltage to the charger?  What do the status and fault registers report?

    Regards,

    Jeff

  • Hi Jeff,

               Thanks for your answer.

    for your information

    Voltage to the charger around 19V.

    Charger Status registers

    0 th -REG(0x1B) is ------0x04----------AC2_Present

    1 st-REG(0x1C) is ------0x10----------------not charging, not qualified adapter, BC1.2 not completed

    2nd-REG(0x1D) is ------0x01---------------Vbat present ( I didn't connect the battery)

    3 rd-REG(0x1E) is ------0xC0----------------ACRB2,ACRB1 are present

    4 th -REG(0x1F) is ------0x00-----------------no TS fault

    Fault Status registers

    0 th -REG(0x20) is ------0x00

    1 st-REG(0x21) is ------0x00

    these are the register reading from I2C

    What is the wrong i have done?

    Please reply me

    Best Regards,

    Malesh Nakka

  • Hi Malesh,

    I answered this in your other post.  So, let's close this one.

    Regards,

    Jeff