TDA3XEVM: Why IR1443 ES2.0 EVM can not be connected to TDA3x EVM

Adam Yao94020

Part Number: TDA3XEVM

Hi champion,
I am running the processor SDK radar 3.2.0.0 applicaiton on TDA3x EVM with DIB, VAB and radar EVM. I find a that the application can run with AR1443 ES1.0 EVM, but can not run with IR1443 ES2.0 EVM. When the IR1443 ES2.0 EVM connected, the radar initializaiton can not pass. Below is the log.

IPU1-0] Enter Choice:
[IPU1-0]
[IPU1-0]   1406.545720 s:
[IPU1-0]   1406.545812 s: CHAINS: Init AR12xx ...
[IPU1-0]   1406.546117 s: UTILS_MCSPI: McSPI is configured in interrupt mode!!

I don't know potential difference between ES1.0 and 2.0 for 1443 which can cause this issue. Could you help to check?

Thanks,
Adam

over 8 years ago

0 Yordan Kamenov over 8 years ago

TI__Mastermind 42515 points

Hi Adam,

I have forwarded your question to a RadarSDK expert.

Regards,
Yordan

0 Piyali Goswami over 8 years ago in reply to Yordan Kamenov

TI__Mastermind 30245 points

Hi Adam,

Would it be possible for you to flash the QSPI flash on the IR1443 board with the firmware as described in the Radar Studio User guide and then boot the device from TDA3x without loading the firmware through SPI?

I remember the IR/AR1443 ES2.0 has to boot from flash always. This is not the case for AR1243. I am reconfirming this with the xWR team.

Thanks and Regards,
Piyali

0 Piyali Goswami over 8 years ago in reply to Piyali Goswami

TI__Mastermind 30245 points

Hi Adam,

I haven’t heard back from you, I’m assuming you were able to resolve your issue. If not, just post a reply below (or create a new thread if the thread has locked due to time-out)

Thanks and Regards,
Piyali

Processors

Processors forum

TDA3XEVM: Why IR1443 ES2.0 EVM can not be connected to TDA3x EVM