TDA3XEVM: DCC Tools

Adriaan Verheij31

Prodigy 180 points

Part Number: TDA3XEVM

Dear TI,

How do I get access to the DCC Tools? I need to write a custom sensor driver for the TDA3.

Thank you,

Adriaan Verheij

over 6 years ago

0 Rishabh Garg over 6 years ago

TI__Guru 55685 points

Hi,

DCC tool can be downloaded from CDDS, please check chapter "3.9 DCC" in VisionSDK_UserGuide_TDA3xx.pdf for exact link to it and tool usage instructions.

Regards,
Rishabh

0 Mayank Mangla over 6 years ago

TI__Mastermind 24525 points

You do not need DCC tool to create a sensor driver. DCC is used only for image quality tuning.

To create a new sensor driver, you can follow these steps

1.Copy DCC profile from another sensor.

2. Modify the XML files in a text editor. Update DCC ID. Please use a ID which is same as the ID specified in sensor driver.

3. Run the script generate_dcc.bat

0 Rishabh Garg over 5 years ago in reply to Mayank Mangla

TI__Guru 55685 points

Hi,

I haven't heard back from you, I'm assuming you were able to resolve your issue.
If not, just post a reply below (or create a new thread if the thread has locked due to time-out).

Regards,
Rishabh

0 Adriaan Verheij31 over 5 years ago in reply to Rishabh Garg

Prodigy 180 points

Rishabh,

I'm sure there will be some tuning necessary, so access to the DCC tools will be very helpful.

Thank you,

Adriaan.

0 Rishabh Garg over 5 years ago in reply to Adriaan Verheij31

TI__Guru 55685 points

Hi Adriaan,

Please get in touch with your TI representative for access to DCC tools.

Regards,

Rishabh

0 Adriaan Verheij31 over 5 years ago in reply to Rishabh Garg

Prodigy 180 points

Rishabh,

I asked the TI rep in Colorado, Philip Meyer, and he referred me to this forum.

0 Mayank Mangla over 5 years ago in reply to Adriaan Verheij31

TI__Mastermind 24525 points

We internally synced up with Philip,. Philip will follow up with you on how to proceed.

Processors

Processors forum

TDA3XEVM: DCC Tools