PROCESSOR-SDK-OMAPL138: About the simultaneous operation of DSP+ARM.

userasagonta55

Part Number: PROCESSOR-SDK-OMAPL138
Other Parts Discussed in Thread: OMAP-L138

I have arm samples and DSP samples, but do you have a sample that works arm and DSP at the same time? Also, if you want CCS to run ARM and DSP at the same time, please let me know if there are any settings or procedures to check when loading and running the program.

over 6 years ago

0 Yordan Kovachev over 6 years ago

TI__Guru**** 161600 points

Hi,

I have arm samples and DSP samples

You could load your application on ARM and DSP cores and then run them, this way you will have both ARM and DSP cores executing your examples.

Best Regards,
Yordan

0 userasagonta55 over 6 years ago in reply to Yordan Kovachev

Intellectual 350 points

What application should I download?
How do I get ARM and DSP to work at the same time in CCS? Manual, how to set, please.

0 Sahin Okur over 6 years ago in reply to userasagonta55

TI__Mastermind 27355 points

Hi fuasa,

You can connect and load code onto both the ARM and DSP cores separately in CCS (you will need to connect to the ARM first to take the DSP out of reset).

The following guide should help. If you have any questions please let us know.

Connecting the LCDK to Code Composer Studio

Regards,
Sahin

0 userasagonta55 over 6 years ago in reply to Sahin Okur

Intellectual 350 points

Hi Sahin.

I was able to set it part way, but I do not know the setting after this.
Processor OMAP-L138 ARM+DPS 6000.
Installer ti-processor-sdk-rtos-omapl138-lcdk-06.00.00.07-Windows-x86.

Code Composer Studio FOR Windows Host IDE CCS9.0.1.00004_win64.

I'm using.

1.Top menu[View]->[Target Condigurations]

2.Double-click Project->targetConfigs-> .ccxml in the Window displayed in Target Condigurations.

3.The Basic tab (which has a toggle tab at the bottom of window, like Excel) appears, so switch to Advanced.

4.For OMAP-L138, as shown in Figure 2.

ARM+DSP.xlsx

Please tell me what to do.