• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 10 subscribers
  • Views 193 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DAC38RF83: Current consumption

Nir Reuveni
Prodigy 40 points
Part Number: DAC38RF83

Hi all

My question is about the -1.8V connected to the dac.

I see almost zero current consumption in the -1.8V DC (I verified that the voltage actually gets to the DAC), and I can't see any output frequency.

I have another DAC that works fine, and the current consumption is 160mA (For the -1.8V).

is there anything i can do in order to fix it?

  • 0
    TI__Guru* 91947 points

    Nir,

    We are going to need more information before we can help you with this.

    1. Is this two identical boards or 2 DAC's on a single board?

    2. Are both outputs dead on the non-working device? What is the status of the JESD SYNC signal? Did this part ever have a valid output?

    3. Can you get a NCO only tone out of the non-working DAC?

    4. Can you send you schematic? If not, what is the device used to supply this voltage?

    5. Can you write/read registers from the non-working DAC? Are the clocks present at this part?

    6. Are any errors reported from the error status registers?

    Regards,

    Jim