GC Studio Download

tanase cristian

Prodigy 20 points

Hello all,

Is there any chance to download CG Studio ?

I have recently ordered some GC 5016 chips and i need this program. I was not able to find'it on TI web-site.

Regards,

Cristian

over 12 years ago

0 jim s over 12 years ago

TI__Guru* 91947 points

Cristian,

We are sending the software via YOUSENDIT. Let us know if you did not receive it

Regards,

Jim

0 tanase cristian over 12 years ago in reply to jim s

Prodigy 20 points

Hi Jim,

Thank you for the link.Everything is ok.

Could you please tell me if is there any information available regarding the initialization of the GC5318 ? In the data sheet is specified that the initialization for this chip is available from TI... and that's it.

Regards,

Cristian

0 Radio-Joe over 12 years ago in reply to tanase cristian

TI__Mastermind 37500 points

Hello

The GC5318 is the DUC only portion of the GC5316. As such, the register programming built up from the GC Studio tool for the GC5316, contains the sync selection and the set of steps used for initializing the device.

You can build the GC5316 project in GC Studio, and then use one of the .gc101 output files to see the register writes done for the programming and initialization.

Regards,

Radio Joe

0 Tom Hurst1 over 12 years ago in reply to Radio-Joe

Prodigy 80 points

I also ordered some of the GC5016 would it be possible to get a copy of the software

Thank you

Tom Hurst

0 jim s over 12 years ago

TI__Guru* 91947 points

Cristian,

Send me your email address and I will send this software using YOUSENDIT.

Regards,

Jim

0 Joe Kolcov over 12 years ago in reply to jim s

Prodigy 15 points

Hello.

Also ordered the GC5016 chip, can you send me this software?

Regards,

Joe.

0 jim s over 12 years ago in reply to Joe Kolcov

TI__Guru* 91947 points

Joe,

Send me your email and I will send you this via YOUSENDIT.

Regards,

Jim

RF & microwave

RF & microwave forum

GC Studio Download