• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 9 subscribers
  • Views 331 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

GC5016 one shot mode

Ondrej Karas19642
Prodigy 20 points

Hello,

I am using Power meter without one shot and it works fine, but in my application is better use one shot. Could you someone detailed explain, how one shot mode work? I do not understand description in datasheet.

In another way: I mean, that there are some error in desctription (page 22) "(page 0x13 address 0x12 bit10 must be 0".

Thank you

  • 0
    TI__Mastermind 37500 points

    Hello,

     

    The GC5016 Power measurement can use an internal count, or a procedure to allow the MPU registers to read the power meter.

    The MPU read one shot, requires a specific sequence in the datasheet.  If your initial method works, I would use that

    Regards,

    radio Joe