IWR6843AOP: Azimuth tilt parameter of the SensorPosition CLI command

Kai

Part Number: IWR6843AOP

Hi,

According to page 12 of 3D_people_counting_tracker_layer_tuning_guide.pdf document, Azimtilt parameter is not supported in "mmwave industrial toolbox 4.6.0".

I was wondering if this parameter is supported in the latest software pack release "mmwave industrial toolbox 4.9.0"?

Cheers,

over 3 years ago

+1 Jackson Thomas over 3 years ago

TI__Genius 14415 points

Hello K,

The azimuth tilt is still not implemented in the tracker. But you can see how the elevation tilt is added and used to see how you can add support for this additional tilt angle.

Regards,

Jackson

Sensors

Sensors forum

IWR6843AOP: Azimuth tilt parameter of the SensorPosition CLI command