AWR1843BOOST: I wants to connect AWR1843BOOST board with non TI processor board

Hi,

Can you please provide more details on what peripheral you plan to use to connect the two boards?

Not clear why you are asking about linux stack for awr1843BOOST?

Please provide more details about your project.

Thank you
Cesar

Hi,

I am planning to connect AWR1843BOOST with Renesas R-CAR V3H board(https://www.renesas.com/us/en/products/automotive-products/automotive-system-chips-socs/r-car-v3h-system-chip-soc-designed-intelligent-camera-deep-learning-capabilities). In AWR1843BOOST J6 connector is to connect with the other processor board, but I am not able to understand few pinouts of the J5& J6 connector of AWR1843BOOST. Will you please help in doing the connection diagram?

Hi,

Sorry, we still don't have sufficient information to help you.

What peripherals do you plan to use to communicate with the Renesas board?

thank you

Cesar

 The AWR1843BOOST radar output we directly want to send to Renesas board through SPI communication.

Hi,

Please review this TI design. It shows how to connect a BOOST board through SPI.

Even if a different device is used in the ti design, this information also applies to the AWR1843BOOST board.

TIDEP-0091 reference design | TI.com

After you perform the SPI connection between the two boards next step will be to modify the SW that runs on the AWR1843BOOSt board to send the processed data through SPI instead of UART.

Please give me some time to check internally for examples

thank you

Cesar

Hi Caesar,
I am going through the links that you have shared. Examples will be more helpful if it is available.

Will you please send the example code for RADAR processing?

Thank You
Mohd Ashad Khan