• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 29 subscribers
  • Views 459 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

AWR1843BOOST: Using the MMWAVE DEMO VISUALIZER Config file

Guruvishnuvardan Mounagurusamy
Intellectual 280 points
Part Number: AWR1843BOOST

Hi,

Good Day!

Can you please let me know, if I can use an old config file(Stored in PC) from MMWAVE demo visualizer to an AWR1843BOOST that is flashed recently? Or Can I only use those Config sent to MMWAVE device  from demo visualizer?

My Apologies, if it's a stupid question, Kindly Respond.

Thanks

Guru

  • 0
    TI__Guru*** 148584 points

    Hi,

    First I assume that the AWR1843BOOST was flashed with the mmWave SDK demo.

    The config file generated with the MMWAVE demo visualizer is specific to the mmWave SDK demo.

    Please make sure that the version of the MMWave demo visualizer used to generate the config file is supported by the  mmWave SDK  version. 

    If you have generated the config file in the last 1.5 years this should be fine.

    Then you can open this Visualizer, go to the "Plots" window and click on "LOAD CONFIG FROM PC AND SEND"

    Thank you

    Cesar

  • 0 in reply to Cesar
    Intellectual 280 points

    Hi Cesar,

    Good Day!

    Thanks for the Response. It resolved my issue.

    Additionally, Can you please let me know, What "Typical Detectable Objects" denotes in MMWAVE sensing estimator?

    Thanks

    Guru