TMAG5111: TMAG5111C4

ANKIT JANGID

Part Number: TMAG5111

Hello all,

I am using this hall sensor with rotating magnetic encoder >20mT.

I connected 0.01uf at VCC and GND as per data sheet, and resistance value 1 k is connected to VCC to pull up the output pin .

RESULT: Output is Okay 70% time this sensor is giving data countiniously, but 30% time the output pin is suddenly forced to low (0Volt).

after restart the sensor works correctly.

over 2 years ago

0 ANKIT JANGID over 2 years ago

Prodigy 10 points

Please suggest the circuit for the voltage range 6volt,10volt,18volt

and suggest the problem

0 Isaac Lara over 2 years ago in reply to ANKIT JANGID

TI__Mastermind 21650 points

Hello Ankit,

Thank you for posting to the sensors forum! The team is currently out of office due to a US holiday, we will submit a response tomorrow when the team is back in the office. Thank you for your patience!

Best,

Isaac

0 John Miller - Sensing over 2 years ago in reply to Isaac Lara

TI__Mastermind 34895 points

Ankit,

Would you please provide a little more detail on the output behavior?
You said 70% of the time, the output is okay, but for 30% of the time, it goes low.
For example, does this happen over a repetitive change of the input field, or over a single unchanging value?

regards,
John

Sensors

Sensors forum

TMAG5111: TMAG5111C4