This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

IWR6843AOPEVM: Overhead_demo_visualizer.exe does not start

Part Number: IWR6843AOPEVM
Other Parts Discussed in Thread: MMWAVEICBOOST

Hi TI-team

I would like to rate Overhead 3D People Counting.

IWR6843AOPEVM(REV.F) and MMWAVEICBOOST are connected.

SDK: mmwave_sdk_03_05_00_04

MATLAB Runtime: version 9.11 (R2021b)

FW:overhead_3d_people_count_demo_default.bin

MMWAVEICBOOST: SOP0=OFF,SOP1=OFF,SOP2=ON

IWR6843AOPEVM: S1=1ON,2ON,3ON,4OFF S2=1OFF,2ON,3OFF,4OFF.

After setting up the above I followed the instructions below.

  1. Navigate to <INDUSTRIAL_TOOLBOX_INSTALL_DIR>\mmwave_industrial_toolbox_<VER>\labs\people_counting\overhead_3d_people_counting\gui
  2. Double click to launch overhead_demo_visualizer.exe
  3. A black console window will appear. After 30-60sec, a Configuration window will appear as shown below.

When I double click to launch overhead_demo_visualizer.exe, the following image rises but disappears in a few seconds.

Could you please tell me how to get it to start up properly ?

Best Regards,

Koji Hayashi