Hello Team TI,
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello Team TI,
Hello.
I would recommend you look at the parking garage sensor demo, which uses the IWR6843ISK to detect parked or stationary cars in parking spaces. To tune it for low power, you can take a look a the low power demo in the fundamental folder within the labs folder in the industrial toolbox. I have linked both below.
Hope this helps,
Santosh
Parking Garage Sensor Demo: https://dev.ti.com/tirex/explore/node?node=AGiLElbLVy.mbS4md38yWw__VLyFKFf__4.12
Low Power Demo: https://dev.ti.com/tirex/explore/node?node=ALNwx9A2x.o5T7wR85tZlQ__VLyFKFf__4.12
Hello.
We are very thankful for supporting us.
From our point of view IWR6843ISK is a high end parking sensor. As all areas are not equal in size it requires to configure / calibrate each sensor according to it's area.
In our case we are planning to fix device on Road surface or bury inside the road at the center of parking lot. In this method we can keep same configuration for all devices so that non technical person can also install the device easily.
Also our SMD setup is capable of SOIC, SOC packages.
So we are looking for simple solution with one sensor for one vehicle.
Kindly suggest sensor suitable for above requirement.
Hi Madhav,
Thank you for the feedback. This is the best device we have at this time in the mmWave space.
Thanks again,
Angie