IWR6843AOPEVM: run dpu unit tests on top of SysBios

REDA EL HAIL

Part Number: IWR6843AOPEVM
Other Parts Discussed in Thread: SYSBIOS, IWR6843AOP

Hello,

I would like to run the dpu unit tests on CCS on top of sysbios. I found the test files and imported them to CCS. But I am not able to figure out how should i use CCS to run this code.

The folder i am talking about exists in: mmwave_sdk_\packages\ti\datapath\dpu\rangeproc\test

Could you please provide some help with that?

Bests,

Reda

over 3 years ago

+1 Josh Dye over 3 years ago

TI__Mastermind 20901 points

Hi Reda,

You can refer to section 3.5 of the mmWave SDK User Guide which details running the unit tests.

When running the unit tests for drivers and other components, it is recommended to use CCS development/debug mode. For more detailed instructions, please refer to this document in the Industrial Toolbox regarding Using CCS Debug.

Note: If you are using an IWR6843AOP EVM, then the MMWAVEICBOOST carrier board must be used to connect to the PC with the onboard XDS110.

Best Regards,

Josh

+1 REDA EL HAIL over 3 years ago in reply to Josh Dye

Prodigy 98 points

Thank you for the prompt answer, it is working now.

Is there any documentation to understand the output of unit tests?

Best regards,

Reda

+1 Josh Dye over 3 years ago in reply to REDA EL HAIL

TI__Mastermind 20901 points

Hi Reda,

I apologize for the delayed response. When running the DPU unit tests, you should see pass/fail in the CCS console.

Best Regards,

Josh

Sensors

Sensors forum

IWR6843AOPEVM: run dpu unit tests on top of SysBios