AWR1843AOPEVM: Deployment mode vs Debug mode

Ali AAK

Part Number: AWR1843AOPEVM
Other Parts Discussed in Thread: MMWAVEICBOOST,

Hi,

I read from application notes that there are tow modes, Deployment mode and Debug mode. what are my access differences to chip programming and applications in these two modes? and if i use Debug mode by AWR1843AOPEVM, should i have MMWAVEICBOOST too?

Thank you very much

over 2 years ago

+1 Saswat Kumar over 2 years ago

TI__Mastermind 35145 points

Hello Ali,

The difference between the debug and Deployment code is the level of optimization that compiler does. The debug code is not optimized and is used when you want to run through the code line by line and debug.
Yes, you will need the MMWAVEICBOOST for debug or development mode.

Regards,
Saswat Kumar

0 Ali AAK over 2 years ago in reply to Saswat Kumar

Prodigy 180 points

Thank you so much Saswat. It was complete answer.

Sensors

Sensors forum

AWR1843AOPEVM: Deployment mode vs Debug mode