IVC102: IVC102 noise index unqualified

jeno.zhang

Part Number: IVC102

2705.IVC102 Chip Sampling Test Report.pdf

Hello，

IVC102 found that the noise index was unqualified during the test. Please see the attachment for details. Please help analyze the cause. Thanks!

over 2 years ago

0 Brent Elliott over 2 years ago

TI__Expert 6800 points

Hi,

Our main apps engineer for this part is out of office today. He will get back to you on this in the next 2 days.

Thank you,

Brent Elliott

0 Alex Bhandari-Young over 2 years ago in reply to Brent Elliott

TI__Mastermind 25855 points

Hi,

Can you please elaborate on the test you are conducting. Is there a particular datasheet spec that is being violated?

Best,

Alex

0 Holly Hong over 2 years ago in reply to Alex Bhandari-Young

TI__Intellectual 1850 points

below is the schematic, could you help check schematic first?

0 Praveen Aroul over 2 years ago in reply to Holly Hong

TI__Mastermind 49796 points

Hi Holly,

Because of the holidays, our responses are delayed through Jan. 3. Thank you for your patience.

0 Alex Bhandari-Young over 2 years ago in reply to Praveen Aroul

TI__Mastermind 25855 points

Hi Holly,

I want to note that our support for this part is limited to what is in the datasheet. We are now handling queries on this device at the following address: IVC102-support@list.ti.com

For your question, can you supply what is at the input node: SI0? If you can follow up through email we can support this further there.

Best,

Alex

Sensors

Sensors forum

IVC102: IVC102 noise index unqualified