AWRL6432: Tx output back off and Rx gain control.

Woong Choi

Intellectual 295 points

Part Number: AWRL6432

Dear TI team

There is a comment for DFE feature support in SWRS295( awrl6432 data sheet).

TX output back-off and Rx gain control interfaces are needed.

Let me know the sw interface or API for these.

Best and regards

Choi

over 2 years ago

0 Pedrhom Nafisi over 2 years ago

TI__Mastermind 23147 points

Hello Choi,

You can change these parameters via configuration file (.cfg) that is sent to the device. Within the SDK-L, you can open up the SDK User guide and go to the Motion and Presence example and demo page. You should look at factoryCalibcfg.

C:/ti/MMWAVE_L_SDK_05_01_00_04/docs/api_guide_xwrL64xx/EXAMPLES_MOTION_AND_PRESENCE_DETECTION.html

Best Regards,

Pedrhom Nafisi

0 Woong Choi over 2 years ago in reply to Pedrhom Nafisi

Intellectual 295 points

Dear Pedrhom Nafisi.

Thanks for your answer.

which Item do you mean?

Do you mean factoryCalicfg.rxGain and factoryCalicfg.backoff0?

If correct, I understand.

please check the Item.

Best and regards.

Choi.

0 Pedrhom Nafisi over 2 years ago in reply to Woong Choi

TI__Mastermind 23147 points

Correct those are the two I am talking about.

Best Regards,

Pedrhom

0 Woong Choi over 2 years ago in reply to Pedrhom Nafisi

Intellectual 295 points

Dear Pedrhom Nafisi

Appreciate.

Best and Regards

Choi

Sensors

Sensors forum

AWRL6432: Tx output back off and Rx gain control.