IWRL6432: How to save motion-detected processed data when using L6432 Visualizer

Jack

Mastermind 9145 points

Part Number: IWRL6432
Other Parts Discussed in Thread: IWR6843,

Hi TI

Is there a way to save the motion-detected Processed Data?

My customer said it was available from IWR6843 Demo Visualizer. But they unable to find it for L6432.

I didn't ask you about Raw Data Capture using the DAC1000 board.

Regards,

Jack

over 2 years ago

0 Nathan Block over 2 years ago

TI__Mastermind 37805 points

Hi Jack,

This is not possible currently in the IWRL6432 visualizer. Compatibility with the IWRL6432 is planned for an upcoming release of the Industrial Visualizer though, and it will support saving data. Please check back again in a few weeks.

Best,

Nate

0 Jack over 2 years ago in reply to Nathan Block

Mastermind 9145 points

Thanks Nathan for your prompt answer.

0 Jack over 2 years ago in reply to Jack

Mastermind 9145 points

Hi Nathan.

Can you give me a rough idea of when it will be released? The client company asked me about the development schedule.

The processed UART output data to be saved into txt file when using Demo Visualizer.

Thanks.

Regards,

Jack

0 Nathan Block over 2 years ago in reply to Jack

TI__Mastermind 37805 points

Hi Jack,

I would expect within the next two weeks, but this is subject to change.

Best,

Nate

Sensors

Sensors forum

IWRL6432: How to save motion-detected processed data when using L6432 Visualizer