• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 30 subscribers
  • Views 368 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DCA1000EVM: How can reboot or reset the DCA1000EVM board

houdali nabil
Intellectual 280 points
Part Number: DCA1000EVM
Other Parts Discussed in Thread: MMWAVEICBOOST

Hi,

While trying to capture raw data via mmwave studio cli.exe the DCA board won't launch and I can't detect a port in device manager. So, I'm wondering if exists any way to reset the dca1000evm board or another solution?

Thanks

  • +1
    TI__Mastermind 20605 points

    Hi Houdali,

    Your SOP switch settings appear to be incorrect from the pics shown above when using the EVM without MMWAVEICBOOST board. Please refer to Page 9 of the following document for the right settings.

    mmWave_sensor_raw_data_capture_using_DCA1000_xwr6843.pdf

    I would also request you to do the following once you've completed the steps above.

    • Can you please confirm if you have installed the FTDI drivers?
    • Can you also confirm if you are able to see the XDS ports for the radar EVM?
    • I would also request you to verify the physical connections between the 2 EVMs.

    Regards,

    Kaushik