IWR6843: How to update presenceBoundaryBox parameters in runtime?

Mustafa Homsi

Part Number: IWR6843

Hello, we tried to update the presenceBoundaryBox parameters while the sensor is enabled and running, but the new settings don't seem to be updated. We got no error when we sent the "presenceBoundaryBox" command while the sensor was running. It just doesn't seem to make any difference.

Is it possible to update presenceBoundaryBox parameters while the sensor is running?

Thank you.

over 2 years ago

0 Tim Henderson over 2 years ago

TI__Expert 8802 points

Hi,

Could you provide me a little more detail about your current setup? Specifically, which demo are you trying to run?

Thank you,

Tim

0 Mustafa Homsi over 2 years ago in reply to Tim Henderson

Expert 1171 points

We are using the people counting lab within the radar toolbox 1.0.0.26.

0 Tim Henderson over 2 years ago in reply to Mustafa Homsi

TI__Expert 8802 points

Hi,

The people counting demo does not support re-configuration (sending the configuration again while the demo is running). In general, a reset is needed between sending configurations.

Regards,

Tim

Sensors

Sensors forum

IWR6843: How to update presenceBoundaryBox parameters in runtime?