IWRL6432: About configuration settings on sensor restart

Masaya Yamagishi

Part Number: IWRL6432

Hi team,

I sent the config, sensorStart, and after a while I sent sensorStop.
In that state, if I send only the sensor start without resending the sensor reset and configuration, will the sensor work with the first sent configuration?

Best Regards,

Masaya Yamagishi

over 2 years ago

0 Josh Dye over 2 years ago

TI__Mastermind 20781 points

Hi Yamagishi-san,

Yes, this is the expected behavior however please note that currently (SDK5.2) sensorStop is not supported when low power modes are enabled. This limitation is listed in the release notes for the SDK.

Best Regards,

Josh

0 Masaya Yamagishi over 2 years ago in reply to Josh Dye

Prodigy 130 points

Hi Josh-san,

Thank you for your confirmation.
I understood how the sensors behave.

Best Regards,

Masaya Yamagishi.

Sensors

Sensors forum

IWRL6432: About configuration settings on sensor restart