IWR1443BOOST: Disconnected and Timed out issue.

Haozheng Fan

Prodigy 20 points

Part Number: IWR1443BOOST

Hi,

I am currently working on mmWave studio to capture data with IWR1443Boost+DCA1000 combination.

When I set it up it keep giving me timeout error I dont know how to fixed it. the set up is exactly as the instruction.

over 2 years ago

0 Pedrhom Nafisi over 2 years ago

TI__Mastermind 22927 points

Hello

Unable to read FPGA version is one of the most common errors found when attempting raw data capture with a DCA1000. Unfortunately the error is vague and it can be due to several different reasons, but the error is a result of the computer not being able to communicate with the DCA1000 properly. Just to confirm, are you using the instructions found in the most updated DCA1000 guide found in the Radar Toolbox?

https://dev.ti.com/tirex/explore/node?a=1AslXXD__1.20.00.11&node=A__AGTrhNYW8jE6cMxbovlfaA__radar_toolbox__1AslXXD__1.20.00.11

Also ensure the following:

Proper settings of static IP
Power supply is 5V 3A, might work with 2.5A
Cables are good, switch out ethernet and USB if possible
Steps in the guide are followed in the exact order shown, especially once mmWaveStudio is opened.

Best Regards,

Pedrhom

Sensors

Sensors forum

IWR1443BOOST: Disconnected and Timed out issue.