In the structure of AWR2944, GPADC is in the RF/Analog subsystem, and main subsystem can use the GPADC for application usage, they are in different subsystem, how does MSS get the ADC value from RF Subsystem ?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
In the structure of AWR2944, GPADC is in the RF/Analog subsystem, and main subsystem can use the GPADC for application usage, they are in different subsystem, how does MSS get the ADC value from RF Subsystem ?
Hi Jin,
There are two instances of ADC's in the SOC. One in the RF subsystem for Radar usage. And another GPADC is in MSS which can used directly like a normal ADC.
For usage of GPADC in MSS, drivers are available in MCU-PLUS SDK of AWR2944 on ti.com
Regards,
Ajay
No, this is for Radar use. You should use the GPADC in the MSS.
Regards,
Ajay
But in TI document, it says it is a shared GPADC,and it has digital pin, am i correct ?
Hi,
Can you please let me know which document you are referring to?
Regards,
Ajay
Hi,
This must be a typo in the safety manual. Can you please let me know the safety manual version you are referring to?
Meanwhile let me check on this and this typo will be fixed in next Safety manual.
In AWR2944, there are two GPADC, one in MSS another in BSS. If your aim is to measure an external analog signal from a pin, then you need to use the MSS GPADC.
Regards,
Ajay
Hi,
Chapter 7.32 is only referring to BSS GPADC. There is a separate Chapter GPADC for MSS, where MSS GPADC is explained.
Regards,
Ajay