AWRL6432BOOST: factoryCalibCfg Function

Liam

Part Number: AWRL6432BOOST

Hi,

I am not sure what this factoryCalibCfg function is using to calibrate for? Is it used for IF performance?

If I set the saveEnable to one, for each device, whether this function will only perform once, and next time to read FLASH?

Thank you

Liam

over 1 year ago

0 Liam over 1 year ago

Prodigy 160 points

And is this the same ATE calibration doing?

+1 Tim Henderson over 1 year ago in reply to Liam

TI__Expert 8802 points

Hi Liam,

The factory calibrations are runtime calibrations done for the RF system (FECSS). You can read from FLASH after performing this once, but it is recommended to perform the calibration on runtime.

This is separate from the ATE calibration data.

Regards,

Tim

0 Liam over 1 year ago in reply to Tim Henderson

Prodigy 160 points

Hi Tim,

Thank you for reply!

Is there any documents detailed factory calibration and ATE calibration? Still not familiar with ATE calibration.

Regards,

Liam

0 Liam over 1 year ago in reply to Liam

Prodigy 160 points

Besides, does runtime performing means setting factoryCalibCfg on 'save mode' in stead of 'restore mode'

Regards,

Liam

+1 Tim Henderson over 1 year ago in reply to Liam

TI__Expert 8802 points

Liam said:
Besides, does runtime performing means setting factoryCalibCfg on 'save mode' in stead of 'restore mode'

Yes.

Liam said:
Is there any documents detailed factory calibration and ATE calibration? Still not familiar with ATE calibration.

x432 Calibration Overview.pdf

0 Liam over 1 year ago in reply to Tim Henderson

Prodigy 160 points

Hi,

Thank you for your help!

Regards

Liam

Sensors

Sensors forum

AWRL6432BOOST: factoryCalibCfg Function