TI-SCB: No SCB controller detected..

kobi cohen1

Prodigy 60 points

Part Number: TI-SCB

Hi,

I purchase "INA228EVM + SCB Controller" and install the driver on my computer.

but when I open the Gui I get the following massage:

Replacing all your recommended drivers but still get this massage :

what can I do with it?

thanks Kobi.

8 months ago

0 Mohamed Hamida 8 months ago

TI__Expert 6602 points

Hi Kobi,

The first step would be to go through all the procedures in the User's Guide located here: https://www.ti.com/lit/ug/sbou241e/sbou241e.pdf. The message of "No SCB Controller Detected" indicates that you have not updated the firmware. You can update the firmware by clicking the following:

Please let me know if you have any further questions. Also, please let me know what procedures you attempt so we can move from there.

Best,

Mohamed

0 kobi cohen1 8 months ago in reply to Mohamed Hamida

Prodigy 60 points

Thanks,

now I have communication to this module, but when I'm measuring on shunt a resistor of 1oHm(very accurate resistor) with a volt meter I get 1.5mV

but unfortunately the data from INA228 is 4mA (suppose to be 1.5mA).
Please advise.
thanks Kobi.

0 Mohamed Hamida 8 months ago in reply to kobi cohen1

TI__Expert 6602 points

Hi Kobi,

It seems that this is a duplicate of another thread. I will close this out and we will support on that thread.

Sensors

Sensors forum

TI-SCB: No SCB controller detected..