PGA305EVM-034: Does it support development for PGA300, PGA305 and PGA900?

Igor Giterman

Prodigy 145 points

Part Number: PGA305EVM-034

Does it support development for PGA300, PGA305 and PGA900?

8 months ago

+1 Bob Benjamin 8 months ago

TI__Guru** 113765 points

Hi Igor,

Welcome to the E2E forum! Basically the difference in the EVM hardware is the device that is in the socket. So it is possible to use the same hardware and replace the device in the socket from the PGA305 to the PGA300 or PGA900. As far as the meaning of development, it is not entirely clear as to what you are hoping to accomplish. In the case of the PGA305 and PGA300, these devices are preprogrammed, closed core and no firmware development can be done with these devices. The PGA900 is an open core M0 device and you would need to write firmware code for this device to be fully operational.

As far as the EVM GUI, each device has it's own GUI for talking to the device(s) from a PC.

Best regards,

Bob B

0 Igor Giterman 8 months ago in reply to Bob Benjamin

Prodigy 145 points

Thank you for your help.

Do you happened to have an algorithm that computes calibration and temperature compensation coefficients.

I need to create my own code for production equipment.

If do not have the algorithm, do you know somebody that has.

It will same me a lot of time writing this piece of code.

Thank you for your help.

Regards,

Igor

0 Bob Benjamin 8 months ago in reply to Igor Giterman

TI__Guru** 113765 points

Hi Igor,

See if you can use the information in the following thread:

https://e2e.ti.com/support/sensors-group/sensors/f/sensors-forum/852425/pga305-data-representation-coefficients-calculation

Best regards,

Bob B

Sensors

Sensors forum

PGA305EVM-034: Does it support development for PGA300, PGA305 and PGA900?