IWRL6432BOOST: load CFG once and board saved the config to load automaticlly on next reboot

Eddy Lai

Prodigy 230 points

Part Number: IWRL6432BOOST

How to make the board to save the config (.CFG) upload by visualizer , and use the config on next reboot automatically?

over 1 year ago

+1 Abhishek Karkisaval over 1 year ago

TI__Genius 11990 points

Hi,

You need to save the configuration sent at first in the flash and reload the configuration the next time you boot up.

If you already know the configuration and you can store the default configuration in the application and start running the application with the default cfg after boot up

Regards

0 Eddy Lai over 1 year ago in reply to Abhishek Karkisaval

Prodigy 230 points

what API can be used to store parameters to FLASH in the application? to save to a file or a specific block?

+1 Abhishek Karkisaval over 1 year ago in reply to Eddy Lai

TI__Genius 11990 points

There are APIs from saving the calibration values, you will have to modify then to your application to save the configuration in the flash and retrive them

Refer to mmwDemo_flashWrite and mmwDemo_flashRead function in factory_cal.c in MMWAVE_SDK 5.4.0.1

Regards

Sensors

Sensors forum

IWRL6432BOOST: load CFG once and board saved the config to load automaticlly on next reboot