Sensors

Sensors forum

AWRL6432: Error in capon2D demo

Liam

Prodigy 150 points

Part Number: AWRL6432

Hi experts,

I am using 6432 evm board with Capon2D demo imported from radar toolbox 2.0 in resource explorer.

First I flash 'motion_and_presence_detection_demo.Release.appimage' compiled in Capon2D demo. It runs successfully with pre-provided .cfg in Matlab Gui.

Then I want to debug this demo, I flash empty.release.appimage in SDKL 5.4. It fails.

0 Liam 10 months ago

Prodigy 150 points

And LowPowerCfg is set 0.

Thank you
liam

0 Liam 10 months ago

Prodigy 150 points

I have seen this. So is it the only way for debugging?

Thank you
Liam

0 Liam 10 months ago

Prodigy 150 points

I have seen this. So is it the only way for debugging?

Thank you
Liam

+1 zigang Yang 10 months ago in reply to Liam

TI__Mastermind 38235 points

Hi, Liam:

Could you give more details on where did you fail? Did you build the debug mode, and get stuck when run with the visualzier?

If so, you can increase the frame duration to a very large number and give a try.

Best,

Zigang

0 Liam 10 months ago in reply to zigang Yang

Prodigy 150 points

Hi Zigang,
Thank you for your reply.
I have tried to increase the frame duration and it worked.

Best,
Liam

0 zigang Yang 10 months ago in reply to Liam

TI__Mastermind 38235 points

HI, Liam:

That is great! I am closing this e2e thread.

Best,

Zigang