DCA1000EVM: Raw data capture with mmWave studio CLI using DCA1000EVM and IWR1843

Zhihua Jiang

Prodigy 70 points

Part Number: DCA1000EVM
Other Parts Discussed in Thread: IWR1843

Hi E2E support team,

Hope this message finds you well.

I am writing cause I have some confusedness while I am using mmWave CLI and DCA1000EVM to capture raw data of IWR1843.

I am wondering how can I set up the sensor configuration(frames, chirps, sample rate, time ...) in mmwave studio CLI?

It seems it started capture the raw data automatically while I running the mmwave_studio_cli.exe.

Best,

Zhihua

3 months ago

0 Pedrhom Nafisi 3 months ago

TI__Genius 15276 points

Hello Zhihua,

Please follow the steps seen in the DCA1000 User Guide on the Radar Toolbox in the TI Developer Zone. It will cover going over manually setting up parameters.

https://dev.ti.com/tirex/explore/node?a=1AslXXD__2.10.00.04&node=A__AGTrhNYW8jE6cMxbovlfaA__radar_toolbox__1AslXXD__2.10.00.04

Best Regards,

Pedrhom

0 Zhihua Jiang 3 months ago in reply to Pedrhom Nafisi

Prodigy 70 points

Hi Pedrhom,

Thanks for the reply, but I am using the mmWave studio CLI, instead of the mmWave studio. I am confused about how to modify the configuration of IWR1843, I didn't see anything related to the parameters settings in CLI in the above document, could you give me some detail about CLI?

Best,

Zhihua

0 Pedrhom Nafisi 3 months ago in reply to Zhihua Jiang

TI__Genius 15276 points

Hello Zhihua,

Have you checked the mmWave Studio CLI Developers Guide?

https://dev.ti.com/tirex/explore/node?a=1AslXXD__2.10.00.04&node=A__AL.2jQSfr.cBlIPkmyqXjA__radar_toolbox__1AslXXD__2.10.00.04

And within the Radar Toolbox in the src folder for studio_cli, you can find example CFGs that configure the parameters you care about.

C:\ti\<RADAR_TOOLBOX>\tools\studio_cli\src\profiles

Best Regards,

Pedrhom

Sensors

Sensors forum

DCA1000EVM: Raw data capture with mmWave studio CLI using DCA1000EVM and IWR1843