Other Parts Discussed in Thread: AWR2243, AWR1843
Tool/software:
目前我已经学会如何在AWER1843上面下载demo,现在我想进行如下操作:由AWR1843上电启动硬件触发测量,然后发送同步信号给AWR224,让AWR2243进行测量,并存储数据,请问AWR2243应该如何与AWR1843进行连接呢?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
It is not recommended to use a setup like this, since the synchronization will be difficult to achieve.
Regards,
Shruti
Thank you for your reply, can you clarify what exactly is difficult about it
Can't a program like AWR1843 open for a period of time, send a wave to AWR2243 at the end of it, and in letting AWR2243 make measurements be implemented?
Hi,
From what I understand, you want to start chirping from 1843, once you start it, you need to send a sync signal to 2243 so that it will also start transmitting and receiving the chirp. The synchronization between both the boards is difficult to achieve.
Also, what is your actual use case here?
Regards,
Shruti
I need detection data from two different types of radars, and I hope to achieve angle super-resolution through algorithms. Specifically, it is hoped that the data collection performance of AWR1843 can be improved to the level of AWR2243 through algorithms, and so on, by increasing the detection accuracy and level of lower versions of radar through algorithms.