IWR6843AOP: Industrial Communication Ports

Berke ARSLAN

Part Number: IWR6843AOP
Other Parts Discussed in Thread: DCA1000EVM

Tool/software:

I'm working on a "Industrial Radar" project using the IWR6843AOP chip. Although this chip supports CAN-FD bus, I cannot use it for my industrial project. Instead I need to integrate the HART communication protocol or Ethernet to IWR6843AOP for my application. Are there any connection types and ICs you can recommend?

Thanks,

Berke.

over 1 year ago

0 Santosh Krishnan over 1 year ago

TI__Mastermind 19240 points

Hello.

The IWR6843AOP can use UART communication. The out of box demo enables using UART to transmit data from the sensor to a host and be plotted on a visualizer.

Sincerely,

Santosh

0 Berke ARSLAN over 1 year ago in reply to Santosh Krishnan

Prodigy 20 points

Thanks for your answer. But for my project i need ethernet and HART communication protocols. Is there any connection types for them?

0 Santosh Krishnan over 1 year ago in reply to Berke ARSLAN

TI__Mastermind 19240 points

Hello.

I don't believe there is any support for the HART communication protocol, but if you want to use Ethernet you can look into using the DCA1000EVM, although the Ethernet is primarily used for collecting raw ADC sample data and not for communicating with the device. Primarily the device would use UART, SPI, CAN-FD, or I2C.

Sincerely,

Santosh

Sensors

Sensors forum

IWR6843AOP: Industrial Communication Ports