MMWAVE-STUDIO: DCA1000EVM

AMIRAH BINTI AZMI

Part Number: MMWAVE-STUDIO

Tool/software:

How do I save the data obtained from the software?

I'm having trouble reviewing back the data I recorded. I would like to inquire if there is a way for me to review back the data in the post-process format, where there are multiple types of graphs given.

I'm planning on collecting a few sets of data, and I want to be able to view the graphs (including the frames illustration).

over 1 year ago

0 E. Shareef over 1 year ago

TI__Genius 15820 points

Data Obtained from mmWaveStudio can be saved using the below tab.

In order to review old data, please save each data and the corresponding config with a different name.

You can then re-open studio at a later date and run the config followed by simply browsing for the data and running "PostProc"

Hope this helps,

E. Shareef

0 AMIRAH BINTI AZMI over 1 year ago in reply to E. Shareef

Prodigy 20 points

So does this mean, correct me if I'm wrong, that every time I run the PostProc under the same dump file, that process actually rewrites all the data inside the selected dump file instead of updating it with new data? Because I've tinkered a bit with MATLAB to process the data to get complex data, and have noticed that both (I have an adc_data_1 and an adc_data_2) resulted in the same complex data when I paired it with adc_data_bin.

0 E. Shareef over 1 year ago in reply to AMIRAH BINTI AZMI

TI__Genius 15820 points

Post Proc simply reads the dump and shows the response.

However, if you trigger with the same file name, data will get re-written if using defaul file path and name.

Hope this helps.

E. Shareef

0 AMIRAH BINTI AZMI over 1 year ago in reply to E. Shareef

Prodigy 20 points

I see, thank you for the clarification. It has been helpful.

Sensors

Sensors forum

MMWAVE-STUDIO: DCA1000EVM