TDC7200EVM: How to use TDC7200EVM on Windows 11

Hello Sho,

I don't think we have tested this EVM with Windows 11, but you may just need to load the firmware first.  See section 5.2 of the TDC7200EVM users guide for instructions.  Let me know if this works for you.

Thank you for your reply.
I updated the firmware, but the problem was not solved. After the update, one more COM port was recognized.

Can you check if the board is working properly on a Win10 machine if you have one available?  I want to rule out any issue with the board or firmware.

Unfortunately I don't have a Windows 10 machine.
I followed the instructions on another page to write the firmware using the UniFlash tool, and the following message appeared in Device Manager.
However, I cannot connect using the GUI.

Hello Kimura-san,

I will be taking over the thread while Eddie is out of office. This looks like it was flashed correctly, you should be connecting to the USB one towards the bottom, I am not sure what this says in Japanese but it should say USB Serial Device (COMx). Typically mine is in order based on the MSP ones above so for you it should be COM11. On my windows 11 machine it works without any issues.

Have you tried connecting this one to the GUI yet?

Best,

Isaac

Hello
Unfortunately, I was unable to connect using my Windows 11 machine.

I remembered that I have a Windows 7 machine in my warehouse, and when I checked it, it worked fine. It would be easier to work if it could run on Windows 11, but there's nothing I can do.

Please close this for now as it may not be possible to resolve this due to hardware compatibility issues.
Thank you for your assistance so far.

Thanks for the update Kimura-san, apologies for the inconvenience.

Best,

Isaac