TMAG3001: figure 6-2 clarification

Cameron Wutzke

Expert 3532 points

Part Number: TMAG3001

Tool/software:

just want to confirm, is the image in the datasheet top down? (the one that says ball c2)

6 months ago

0 Cameron Wutzke 6 months ago

TI__Expert 3532 points

for a wee bit more flavor, our overall goal is getting the magnet in-axis with the sensor. Open to any further wisdoms you pros have

0 Alicia Rosenberger 6 months ago in reply to Cameron Wutzke

TI__Genius 13630 points

Hi Cameron,

Thank you for posting to the Sensors forum!

Figure 6-2 is shown top down. To make sure that the magnet is on-axis, you just need to line the center of the magnet up with the sensing element for the axis that you want the magnet to be centered on.

Best,

~Alicia