AWR2944EVM: The location of Ramp Timing Calculator in mmWave Studio for this chip

Arie Rudnitsky

Part Number: AWR2944EVM
Other Parts Discussed in Thread: AWR2944

Tool/software:

Hi,

I use mmWave Studio 3.1.4.4. for awr2944evm. In the user manual for SDK it is written about Ramp Timing Calculator widget. This widget is mentioned in other documents as well, for example, in Chirp Timing Parameters configuration document. However, when I open Studio Application itself, this widget is absent. Where can I find it?

Arie

3 months ago

0 Aydin Kiasat 3 months ago

TI__Expert 5601 points

Hi Arie,

The ramp time calculator is not available for studio version 3.

Regards,

Aydin

0 Arie Rudnitsky 3 months ago in reply to Aydin Kiasat

Intellectual 330 points

Then, what is the methodology to define the configuration in the case of awr2944? What are the instruments that I have to base on? I went through "Programming Chirp Parameters" document, but it is still high level and when it should go into details, it refers to documentation or SW that doesn't exist - there is no Ramp calculator, nor mmWave_Demo_Visualizer that supports this chip.

0 Arie Rudnitsky 3 months ago in reply to Arie Rudnitsky

Intellectual 330 points

Moreover, how to build the configuration file?

0 Aydin Kiasat 3 months ago in reply to Arie Rudnitsky

TI__Expert 5601 points

Hi Arie,

I've looped in the SW team here to comment.

Regards,

Aydin

0 shruti gupta 3 months ago in reply to Aydin Kiasat

TI__Genius 11250 points

Hi Arie,

The expert is out of office at present. Please expect some delay in response.

Regards,

Shruti

0 Shailesh Joshi 3 months ago in reply to shruti gupta

TI__Expert 4440 points

Hello Arie,

Apologies for the delay in response. What are the parameters that you are trying to configure and need help with? Have you gone through the guidelines in the interface control document for those parameters?

Regards,
Shailesh

Sensors

Sensors forum

AWR2944EVM: The location of Ramp Timing Calculator in mmWave Studio for this chip