AWRL1432BOOST: Flashing without using Mode switches (OTA)

Abhishekh Kumar

Part Number: AWRL1432BOOST

Tool/software:

Is there a way to flash the appimage over UART (or other means) without having to configure the switches S1.1 and S1.2? We are trying to flash the image as if it were part of an OTA process.

Regards

4 days ago

0 zigang Yang 3 days ago

TI__Mastermind 40025 points

Hi, there:

Thank you for reaching us. One of our software engineer will get back to you in a day or two.

Best,
Zigang

0 Ajay Narayan 3 days ago

TI__Mastermind 22525 points

Hi Abhishekh,

OTA should be handled by customer Application, UART based Flashing with Switch settings can be used during initial flashing during manufacturing and for further OTA, Application can handle the OTA process.

Regards,

Ajay

0 Abhishekh Kumar 2 days ago in reply to Ajay Narayan

Prodigy 120 points

My question is how can one flash another appimage without the need to set the switches again.

Sensors

Sensors forum

AWRL1432BOOST: Flashing without using Mode switches (OTA)