AWR2243BOOST: AWR2243Boost Configuration with DCA1000EVM

Hemanth_ast

Prodigy 90 points

Part Number: AWR2243BOOST
Other Parts Discussed in Thread: DCA1000EVM, AWR2243

Tool/software:

I am using AWR2243Boost + DCA1000EVM,

i just want some clarity in term of AWR2243 configuration over SPI,

How does it happen by DCA1000EVM?

How USB converts into SPI over FTDI, any special TI Based , software / firmware is needed?

and there is a another USB on AWR2243Boost , what is the role of that USB?

3 days ago

0 Gabriel Gigliotti 2 days ago

TI__Expert 3330 points

Hello,

DCA is needed to run studio which is main tool for awr2243 configuration.

Studio version 3.0.0.14 is used for the AWR2243. Follow the mmwave_studio_user_guide.pdf in the docs folder present in the studio download to see how to use studio with the board. The studio download will also have the necessary firmware to load.

There is only one USB connection on the AWR2243. This is necessary to connect to the PC and load configurations.

Best,

Gabriel

0 Hemanth_ast 2 days ago in reply to Gabriel Gigliotti

Prodigy 90 points

Thanks Gabriel,

0 Cesar 6 hours ago in reply to Hemanth_ast

TI__Guru*** 148804 points

Thank you
Cesar

Sensors

Sensors forum

AWR2243BOOST: AWR2243Boost Configuration with DCA1000EVM