Reference Design LDC1000 with analog (current ) output

g.spoerl

Hi,

i am searching for a reference design where the LDC1000 is used for a sensor with an analog current output ( stand alone sensor ). For example combined with an MSP and XTR..

Best regards

Georg

over 10 years ago

0 Natallia Holubeva1 over 10 years ago

TI__Expert 6550 points

Hello Georg,

What is your final goal? To use the sensor without the microcontroller?

Best Regards,
Natallia Holubeva

0 g.spoerl over 10 years ago in reply to Natallia Holubeva1

Prodigy 190 points

Hello Natallia,

final goal is to build up a stand alone sensor with an analog current output as customer interface.

It should be as simple and cheap as possible, but i think it is not possible without µC.

I thought an application like that should have been designed by someone else and it is not necesarry to reinvent the wheel.

Best regards

Georg

0 Natallia Holubeva1 over 10 years ago in reply to g.spoerl

TI__Expert 6550 points

Hello Georg,

Please note that you need to set the registers in LDC1000 prior to using it. Therefore, you will need to use a microcontroller.

Best Regards,
Natallia Holubeva

Sensors

Sensors forum

Reference Design LDC1000 with analog (current ) output