LDC161xEVM and LabView ?

skuenstler

Prodigy 10 points

Other Parts Discussed in Thread: LDC1000EVM, LDC1101, LDC1101EVM

Hi,

is there a LabView-Demo Version available for the LDC161x-EvaluationBoard ??

Or can you use the same Demo-Version as for the LDC1000EVM ??

Is there a possibility to log the difference-signal between two coils in LabView ??

Thanks for any support on this!

over 10 years ago

0 Natallia Holubeva1 over 10 years ago

TI__Expert 6550 points

Hello,

Unfortunately the Labview is not supported for LDC16x devices.

Best Regards,
Natallia Holubeva

0 Michael Bergler15 over 8 years ago in reply to Natallia Holubeva1

Prodigy 10 points

Hello,

i would like to run the LDC1101 EVM using labview. Because there is no labview-support for the device, I would like to develop a labview program, going out of the LDC1000 Demo Labview programm. Does something like an command list exist, which lists up the commends to approach the MSP on the evaluation board? Or can you list up the main differences between the firmware of the two µCs on the board? I'm not able to figure out the commands of the firmware of the LDC111 EVM written in python.

Thank you for your support!

Best regards,
Michael

0 Varn Khanna over 8 years ago in reply to Michael Bergler15

TI__Intellectual 2725 points

HI Michael,

The LDC1101EVM communication protocol has been provided in section 3.15 of the EVM User Guide.

Regards,

Varn.

0 Jesse Pedroni over 8 years ago in reply to Michael Bergler15

Prodigy 10 points

Michael,

Please keep me updated on your progress. I currently have the sensor and need to integrate it into my LabVIEW program.

Thanks,
Jesse

0 REVATHI VEILRAJ over 8 years ago in reply to Natallia Holubeva1

Prodigy 70 points

hello

we can use LabVIEW to communicate with LDC 161x devices through I2c .

Sensors

Sensors forum

LDC161xEVM and LabView ?