"DNP" in Schematic?

Eric Tian

Other Parts Discussed in Thread: TDC7200EVM

I found some "DNP" components in the schematic of TDC7200EVM, I know DNP means "not populated by default", but I don't know whether I should solder the components on board or not. How can I determine which components are necessary? Thanks.

over 9 years ago

0 Mahendra Gunawardena over 9 years ago

Expert 1780 points

To the best of my knowledge you don't have to solder components. The board works as it is. The board is pretty much plug and play

0 Eric Tian over 9 years ago in reply to Mahendra Gunawardena

Prodigy 135 points

Hi Mahendra,
Thanks for the reply. Do you know why these "DNP" components are drawn in schematics if they are not needed?

0 Matthew Minasi over 9 years ago

TI__Expert 4725 points

Eric,

DNP stands for "Do Not Populate" and as such are not installed on the EVMs. They are there for use during testing and development.

-Best regards,

Sensors

Sensors forum

"DNP" in Schematic?