AWR1642BOOST: I want to read the ADC data from a demo project provided in sdk, continuously and write it in a file,.

Hello Vinayak,
Sure, we will try to help you through this process.
I recommend you have a look at the following training material that provides guidelines for ADC capture using TSW1400 board : training.ti.com/.../mmWave_sensor_raw_data_capture_using_TSW1400_board_v2.pdf

For this you would need two additional HWs apart from the AWR1642 EVM - the mmwave devpack EVM and the TSW1400 EVM.
Note that this guide uses a radar studio PC tool to configure the RF front end , not an embedded application. So you would not need CCS. The Radar studio tool is part of the DFP package ( www.ti.com/.../mmwave-dfp)

Regards,
Dham

Hello Vivek,
Thanks for reply, but I don't want any other further hardware to be attached to AWR1642BOOST EVM, like in mmWAVE demo Visualizer, how data is continuously it's showing I want to capture that data on to a file. I need just reference for this, through UART how data is stored on L3 memory, so that I can keep on writing the data on file and erasing that data present on L3 for next data. I hope you understood my question.
Help me with this asap.
Thanks,
Vinayak

Sure Vivek.

Thanks,
Vinayak