AWR1443BOOST: how to send .cfg file to AWR1443 in firmware of capture demo

user5041304

Part Number: AWR1443BOOST
Other Parts Discussed in Thread: AWR1443

Hello

I want to know how to send *.cfg file to AWR1443 in firmware of capture demo.

According to section 3.4.2 in sdk guide, commands are sent one by one via COM port by teraterm, and I was able to do it.

I hope there is easier way to send commands like sending *.cfg file including commands.

over 8 years ago

0 Vivek Dham over 8 years ago

TI__Guru 58035 points

Hello,
An easier way to send the complete set of commands is to copy all the commands from the .cfg file and then in the teraterm window (at the prompt) you can paste all of them. This would then send each of the commands one after other.

Regards,
Vivek

0 Vivek Dham over 8 years ago in reply to Vivek Dham

TI__Guru 58035 points

Hello,
Did this help you with your query?

Best regards,
Vivek

0 user5041304 over 8 years ago in reply to Vivek Dham

Prodigy 190 points

Hello,

This way doesn't work in teraterm.

Maybe the reason is line break.

Is there the way to include cfg file directly without pasting command?

0 Vivek Dham over 8 years ago in reply to user5041304

TI__Guru 58035 points

Hello,
I have used the copy paste method in Tera Term and it seemed to work for me.
There is no other way to include the cfg file at present.

regards,
Vivek

Sensors

Sensors forum

AWR1443BOOST: how to send .cfg file to AWR1443 in firmware of capture demo