AWR1243BOOST: AWR1243BOOST mmWave Demo Visualizer connection issue.

Hello Chang,

Have you selected the Platform :xWR14xx in your MMWAVE-DEMO-VISUALIZER ?

If you have not selected the right platform sending configuration to the device will not be successful.

Thanks,

Raghu

----------------------------------------------------------------------------------------------------------

Please click the Verify Answer button on this post if it answers your question.

----------------------------------------------------------------------------------------------------------

Of course, I know I already tried setting for WR14xx platform.

But the result was same.

Best Regards,

Seungtaek

Hello Seungtaek,

Are you still having the connection issue?
If so, can you send the pic of the EVM setup and also the snapshot of the error.

Thanks,
Raghu

After I used 1443 not 1243, it seems that connecting hardware is OK like below.

But Still does not show any traces in PLOT tab.

Hello Chang,
The AWR1243BOOST is intended to output raw ADC samples which is then post processed by external host/ data capture (TSW1400EVM) .
You will not be able to use the AWR1243BOOST with the mmwave-demo visualizer.

The AWR1443BOOST has the hardware accelerators that do the processing of the ADC data and send out the object data over UART to the mmwave-demo visualizer.
In the snapshot you have sent I do not see the "sensorStart" command being successful. You may see the error in the "CCS Console" when you send the sensorStart command. Can you please send the snapshot of the error you see in the CCS Console?

Also I am assuming that you have not done any modifications to the code/configurations? Is this understanding right?

-Raghu

Are you still facing this issue?

-Raghu

No, I cleared out this issue. Thanks for asking.