LDC1312: Sensor data

Hirotaka Matsumoto

Part Number: LDC1312

Hi all

Would you mind if we ask LDC1312?

Could you let us know the cause of sensor data = 0 or FF?
The data sheet shows follows;
-0x000 = under range
-0xfff = over range

For example, when the sensor disconnects(between INX and sensor) or filter setting is incorrect, will the sensor data be 0x000??
And in this case, there is the error flag bit?
So, if you have some comments, could you let us know?

Kind regards,

Hirotaka Matsumoto

over 8 years ago

0 Hirotaka Matsumoto over 8 years ago

Guru 27585 points

Hi all

We guess that your team is so busy, however could you give us the reply?

Kind regards,

Hirotaka Matsumoto

0 Varn Khanna over 8 years ago in reply to Hirotaka Matsumoto

TI__Intellectual 2725 points

Hello Matsumoto-san,

Apologies, we had a long weekend in the US and hence the slightly delayed response.

A disconnected sensor will result in a Watchdog Timeout error with invalid data in the data registers. You can refer to the following document (LDC Sensor Status Monitoring) for more information.

Regards,

Varn

Sensors

Sensors forum

LDC1312: Sensor data