AWR1243: Tx/Rx/LO Dist during chirp reset

radarJunkie

Expert 2090 points

Part Number: AWR1243

Hi,

In the Radar Studio GUI, there are check boxes in the SensorConfig tab which are named TX, RX and LO Dist to disable during chirp reset. What is the difference between shutting off TX and LO Dist ?

Checking TX box disables the transmit W-band PA ? and LO Dist shuts off the K-band LO ?

Thank you,

over 7 years ago

0 Vivek Dham over 7 years ago

TI__Guru 58035 points

Hello RJ,
These options are to enable turning OFF some of the blocks during the inter chirp time (if time permits). The "Tx" and "RX" is basically referring to the blocks in the TX chain , like filters , LNA etc. The "LO Dist" refers to the LO to the TX and RX .

Regards,
Vivek

0 radarJunkie over 7 years ago in reply to Vivek Dham

Expert 2090 points

Thank you, Vivek :)

Sensors

Sensors forum

AWR1243: Tx/Rx/LO Dist during chirp reset