AWR1443BOOST: demoVisualizer, cfarCfg' is not recognized as a CLI command

ZHENGGUO SUN

Part Number: AWR1443BOOST
Other Parts Discussed in Thread: AWR1443, MMWAVE-SDK

Hi everyone,

I have trouble running the TI demovisualizer for my awr1443 boost. I keep getting "cfarCfg' is not recognized as a CLI command" message in the console output, and nothing is plotted in the plots tab.

Thanks in advance for your help.

zheng

over 7 years ago

0 Cesar over 7 years ago

TI__Guru*** 148334 points

Hi,

Make sure that you select the correct version of the mmWave SDK you are using

thank you
cesar

0 ZHENGGUO SUN over 7 years ago in reply to Cesar

Intellectual 425 points

thank you I will check and try again. hope this will solve the problem.

regards,
zheng

0 ZHENGGUO SUN over 7 years ago in reply to Cesar

Intellectual 425 points

Hi Cesar,

I've tried all 3 versions available in the pull down menu, which are
1.0
1.1
1.2.
But the problem persists. also, the the sdk folder name on my computer is "mmwave_sdk_01_01_00_02".
any suggestions?
thank you

zheng

0 Akash Gondalia over 7 years ago in reply to ZHENGGUO SUN

TI__Guru 50240 points

Hello Zheng,

You should definitely try with the latest mmWave-SDK 1.2. Would you be able to post more information such as screenshots of your console output? We need more information in order to assist you.

Akash

0 Akash Gondalia over 7 years ago in reply to Akash Gondalia

TI__Guru 50240 points

Hello Zheng,

You should be using the 1.2 from the pulldown with the binaries from the mmWave-SDK 1.2. Since We haven't heard back from you I'm going to close this thread but feel free to open up a new one!

Cheers,
Akash

0 ZHENGGUO SUN over 7 years ago in reply to Akash Gondalia

Intellectual 425 points

Hi Akash,

sorry about the delay. I think for now it resolved my issue. thank you for your help.

regards,
zhengguo sun

Sensors

Sensors forum

AWR1443BOOST: demoVisualizer, cfarCfg' is not recognized as a CLI command