AWR1243BOOST: Radar Studio : Test Pattern generator

Hi,

Have you been able to use it with a different configuration?

Thank you
Cesar

HI Cesar,

I havent been able to make it work with any configuration that I tried.

If you can say me some specific configuration, I can try and get back to you.

Thanks,

Santhana Raj

Santhana,

I have tested the configuration you used in your post and I have been able to implement it on my EVM. So it does not appear to be an issue with the actual configuration. Have you completed all of the setup tasks in the "DataConfig" tab to ensure that the LVDS lane are enabled?

Regards,
Kyle

Hi Kyle,

Thank you for your confirmation. I would like to ask you whether you have tested in Radar Studio v1.9.2.1 only??

The screenshot of the other settings of LVDS in the data config tab is as below:

As you can see, the LVDS clock rate is set to 900Mbps. All the 3 Tx are made on and all the 4 Rx and 4 lanes are enabled.

The CRC is not enabled, which I believe is giving the error.

Thanks in advance,

Santhana Raj

Santhana,

I would recommend changing the Data Rate from 900 Mbps to 600 Mbps.

Regards,
Kyle

Hi Kyle,

Changing the Data rate to 600Mbps resolved the CRC error in Radar Studio.
But I am not getting the data as configured when I click the TSW ARM- Trigger Frame combination.
I suspect I am doing the procedure wrong. Can you help on this?

I would want the LVDS to work on 900Mbps. I would post a new question on how to make this happen. Thanks for this fix anyway.