CCS/AWR1642BOOST: How mss Transfers Data to GUI？

Gilmmer

Part Number: AWR1642BOOST

Tool/software: Code Composer Studio

Hi,

I am learning mmw_dss_xx16 and mmw_mss_xx16. And i want to figure out which function transfers data to the GUI in mss_main.c ?

Thank you.

over 7 years ago

0 Cesar over 7 years ago

TI__Guru*** 148804 points

In MSS the UART driver is used to send data to the GUI.

The Buffers sent to the GUI must be either in L3 memory or in the Hand Shake Share RAM (HSRAM)

The buffers sent to GUI are defined in the function "int32_t MmwDemo_dssSendProcessOutputToMSS()" in dss_main.c

thank you
Cesar

0 Gilmmer over 7 years ago in reply to Cesar

Intellectual 330 points

Thank you very much, i have found this function.

0 Gilmmer over 7 years ago in reply to Cesar

Intellectual 330 points

hi,

i have another question, how can i output the data from L3 memory and HSRAM ?

thank you

0 Cesar over 7 years ago in reply to Gilmmer

TI__Guru*** 148804 points

Hi,

Please take a look at the same function. The function outputs the data

I will close this thread now

If you have new questions please start a new thread

thank you
Cesar

Sensors

Sensors forum

CCS/AWR1642BOOST: How mss Transfers Data to GUI？