IWR1443: How can I output the raw data

Tianai Kong

Part Number: IWR1443
Other Parts Discussed in Thread: , DCA1000EVM, MMWAVE-SDK

I'm using mmWave sensor IWR1443 and I want to output the raw wave data to parse the difference between objects detected. How can I get the raw data?

over 7 years ago

0 Akash Gondalia over 7 years ago

TI__Guru 50240 points

Hi Tianai,

Best option right now is to interface the IWR1443BOOST with the DCA1000EVM.

Cheers,
Akash

0 Tianai Kong over 7 years ago in reply to Akash Gondalia

Prodigy 40 points

Hi Akash,

Thank you for your answer. But if I don't want to buy another module, is there any other methods to get the raw data？

Regards,
Tianai

0 Tianai Kong over 7 years ago in reply to Akash Gondalia

Prodigy 40 points

Hi Akash,

Thank you for your answer. But if I don't want to buy another module, is there any other methods to get the raw data？

Regards,
Tianai

0 Akash Gondalia over 7 years ago in reply to Tianai Kong

TI__Guru 50240 points

Hi Tianai,

Perhaps you can use the mmWave-SDK to stream raw data over the IWR1443 CSI-2 interface. Previous versions of the mmWave-SDK included a separate capture demo although the recommended method at this time is use the DCA1000EVM.

Link to SDK 1.1.
software-dl.ti.com/.../index_FDS.html

Cheers,
Akash

Sensors

Sensors forum

IWR1443: How can I output the raw data